Nuclias Connect Configuration; Wizard - D-Link DNH-100 User Manual

Nuclias Connect Software User Manual
A wizard is available to guide you through first-time setup of the device. If at any time you wish to re-run the wizard you can
click on the icon to start the wizard.
In the Lan Settings section, the device connection parameters can be configured. These settings allow the management
computer to connect to the device.
Parameter
Get Address From
IP Address
Subnet Mask
Gateway
Primary DNS
Secondary DNS
Synchronize Device
Access Address
In the Date and Time section, parameters about the device time and date can be configured. It is recommended that an NTP
server is used; log and schedule settings are depanding on correct time and date configurations.
Parameter
Time Zone
NTP
NTP Server 1
NTP Server 2
Click Save and the device will automatically restart. Re-login to continue with the wizard.
In the System Settings window, configure the following:
Parameter
Device Access Address
Device Access Port
Web Access Port
Click Next to continue

Nuclias Connect Configuration

Wizard

Description
Click the drop-down menu to choose whether the
DNH-100 will get an IP address from a DHCP server
or to manually set a static IP address. By default it
is set to Static IP Address. Note: DHCP server is not
recommended.
If the above is set to Static IP address, specify an IP
address for the DNH-100.
Specify a subnet mask for the device.
Specify a gateway mask for the device. (Optional)
Specify a primary DNS for the device. (Optional)
Specify a secondary DNS for the device. (Optional)
Check to enable the synchronization of the device
access address. If the device access address is differant
than the LAN IP address and you want to manage
remote APs, this function needs to be disabled.
Description
Click the drop-down menu to select the time zone.
Check to enable use of NTP server(s) to manage
device's date and time.
Specify the NTP Server's address.
Specify the secondary NTP Server's address.
Description
Enter the Nuclias Connect Server application's IP address.
To manage remote APs, the IP address must be a public
IP address; IP mapping is required for instances behind a
firewall or router.
Enter the Nuclias Connect server application's listen
port number. The default value is 8443. For remote AP
management behind a firewall or router, the inboud port
must be opened.
The web access ports as defined during the installation.
The values are predefined.
Page 9
Nuclias Connect Configuration