Step 10: Perform The Ptx3000 Packet Transport Router Initial Software; Configuration; Enter Configuration Mode - Juniper PTX3000 Quick Start Manual

Step 10: Perform the PTX3000 Packet Transport Router Initial Software Configuration

Enter Configuration Mode

Copyright © 2014, Juniper Networks, Inc.
Step 10: Perform the PTX3000 Packet Transport Router Initial Software Configuration
The procedures below connect a packet transport router to the network but do not enable
it to forward traffic. For complete information about enabling the packet transport router
to forward traffic, including examples, see the Junos OS configuration guides.
You configure the packet transport router by issuing Junos OS command-line interface
(CLI) commands, either on a console device attached to the
connection to a network connected to the
NOTE: These procedures enable you to use the
management port. For the initial configuration, use a device attached to the
port.
CON
For more information about the configuration statements in this procedure, see the Junos
OS Administration Library for Routing Devices.
To complete the initial configuration, perform the following procedures:
1. Enter Configuration Mode on page 29
Configure User Accounts and Passwords on page 30
2.
Configure System Attributes on page 30
3.
Commit the Configuration on page 31
4.
To enter configuration mode:
Verify that the packet transport router is powered on.
1.
Log in as the root user. There is no password.
2.
Amnesiac <ttyd0> login: root
Start the CLI.
3.
root@% cli
root>
Enter configuration mode.
4.
root> configure
Entering configuration mode.
[edit]
root#
CON port, or over a telnet
port.
HOST/ETHERNET
HOST/ETHERNET
29