Safety Warnings - Juniper PTX3000 Quick Start Manual

Safety Warnings

Copyright © 2014, Juniper Networks, Inc.
next-hop 192.168.71.254;
retain;
no-readvertise;
}
}
}
Commit the configuration to activate it, and synchronize the configuration. The
2.
synchronize command commits this new configuration on both Routing Engines
simultaneously.
[edit]
root@host# commit synchronize
re0:configuration check succeeds
re1:commit complete
re0:commit complete
If you receive an error message after you issue the
command, you can review the configuration by using the
errors in your configuration. You can delete incorrect entries by using the
command. For example, to delete a hostname from the configuration, issue the
following command:
[edit]
root@host# delete system host-name hostname
(Optional) Configure additional properties by adding the necessary configuration
3.
statements. Then commit the changes to activate them.
[edit]
root@host# commit synchronize
Exit configuration mode.
4.
[edit]
root@host# exit
Exiting configuration mode
root@host>
WARNING: See installation instructions before connecting the packet
transport router. This is a summary of safety warnings. For a complete list of
warnings for this packet transport router, including translations, see the
PTX3000 Packet Transport Router Hardware Guide at
http://www.juniper.net/techpubs/hardware/
WARNING: The intrabuilding port(s) of the packet transport router is suitable
for connection to intrabuilding or unexposed wiring or cabling only. The
intrabuilding port(s) of the packet transport router MUST NOT be metallically
connected to interfaces that connect to the OSP or its wiring. These interfaces
are designed for use as intrabuilding interfaces only (Type 2 or Type 4 ports
Safety Warnings
or
commit commit synchronize
show command to find the
delete
.
commit
33