Router - Juniper PTX3000 Quick Start Manual

PTX3000 Packet Transport Router Quick Start
Step 9: Install the Card Cage Screens on the PTX3000 Packet Transport Router
28
NOTE: The management Ethernet port is not functional until you have
completed the initial configuration.
Turn on the power to the external management device.
4.
Switch on the dedicated customer site circuit breakers to provide power to the AC
5.
power cables. Follow your site's procedures.
Verify that the input and input
1
6.
for each connected input, indicating that the power supplies are receiving power.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
7.
the strap to one of the ESD points on the chassis.
Switch the power switch on one of the AC PSMs to the on position (
8.
blinks momentarily, and then lights steadily.
NOTE: After a power supply is powered on, it can take up to 60 seconds
for status indicators—such as the output status LEDs on the power supply,
the command output, and messages on the LCD on the craft interface—to
indicate that the power supply is functioning normally. Ignore error
indicators that appear during the first 60 seconds.
Verify that the LED on the AC PSM faceplate is lit steadily, indicating that power
OK
9.
supply is correctly installed, functioning properly, and providing power to the DC
outputs.
On the external management device connected to the Routing Engine, monitor the
10.
startup process to verify that the system has booted properly.
NOTE: If the system is completely powered off when you power on the power
supply, the Routing Engine boots as the power supply completes its startup
sequence. If the Routing Engine finishes booting, you must power off the
router before powering it on again. After powering on a power supply, wait
at least 60 seconds before turning it off. After powering off a power supply,
wait at least 60 seconds before turning it back on.
You can optionally install a screen over the upper and lower card cages. Each PTX3000
is shipped with two card cage screens, one screen for the upper card cage and one screen
that covers the SIBs and lower card cage. Captive thumbscrews secure the screen to the
chassis. For more information, see Installing the Front Doors on a PTX3000 Packet
Transport Router in the PTX3000 Packet Transport Router Hardware Guide.
LEDs on the AC PSM faceplates are lit steadily green
2
Copyright © 2014, Juniper Networks, Inc.
). The LED
| OK