Step 9: Perform The Initial Configuration - Juniper TCX1000 Series Quick Start Manual

Step 9: Perform the Initial Configuration

Copyright © 2018, Juniper Networks, Inc.
An IP address is required to manage the TCX1000-RDM20 nodes. TCX1000-RDM20
nodes are DHCP-enabled by default; they automatically acquire an IP address from the
DHCP server when the unit is connected to the LAN. This IP address persists as long as
the node is connected to the LAN. To determine this DHCP assigned address; you can
query the DHCP server with the equipment's MAC address or you can query the equipment
by using a CLI session.
NOTE: NOTE: You must configure each TCX1000-RDM20 with a unique static
IP address. DHCP should be disabled.
Before opening a CLI session, set the following parameter values on the management
console or console server:
Baud rate—115,200
Flow control—None
Data—8
Parity—None
Stop bits—1
Once you have connected to the serial port (see Connect the TCX1000-RDM20 to a
Management Console), enter these commands from the CLI to configure the IP address
for the DCN 0 and DCN 1 ports:
Enter the user ID: superuser
1.
Enter the password: <password>
2.
Step 9: Perform the Initial Configuration
15