Canon iP7200 Series Manual page 589

1401 Five flashes:
1403 Print head is not installed./Print
1405 head is defective.
1830 Six flashes:
1850 A certain period of time has
1851 elapsed while disc label printing
1855 is in progress./The inner cover
1856 (the cover of the disc tray) is
1857 opened or closed.
1858
1680 Seven flashes:
1681 Ink tank is not installed in the
correct position.
1700 Eight flashes:
1710 Ink absorber is almost full.
1310 Ten flashes:
Cannot perform duplex printing.
If printing is in progress and you want to
continue printing, press the printer's
RESUME/CANCEL button with the ink tank
installed. Then printing can continue. Replacing
the ink tank is recommended after the printing.
The printer may be damaged if printing is
continued under the ink out condition.
Replacing an Ink Tank
Note
If multiple ink lamps are flashing, refer to
Checking the Ink Status
status of each ink tank.
The print head may be damaged.
Contact the service center.
If a certain period of time has elapsed while
disc label printing is in progress, the printer
stops initializing.
The printer resumes initializing by pressing
the RESUME/CANCEL button.
Try the operation again following the on-
screen instructions.
If the inner cover (the cover of the disc tray)
is open while printing other than disc label
printing is in progress, close the inner cover,
then press the RESUME/CANCEL button.
If the inner cover is closed when starting
disc label printing, open the inner cover,
place the disc tray, then press the
RESUME/CANCEL button on the printer
When you start printing on paper, close the
inner cover, then press the
RESUME/CANCEL button on the printer.
Do not open or close the inner cover while
printing is in progress, as this can damage
the printer.
Some ink tanks are not installed in the
correct position. (The lamps on the ink tanks
flash.)
More than one ink tanks of the same color
are installed. (The lamps on the ink tanks
flash.)
Confirm that the ink tanks are installed in the
appropriate positions.
Replacing an Ink Tank
The ink absorber is almost full.
The printer has a built-in ink absorber to hold
the ink used during Print Head Cleaning.
Press the printer's RESUME/CANCEL button to
continue printing. Contact the service center.
The size of paper may not be compatible with
automatic duplex printing. The sizes of media
suitable for auto duplex printing are A4, Letter,
A5, and B5. Make sure that the size of the
paper loaded in the printer is correct. Pressing
and confirm the