Canon iP7200 Series Manual page 573

Home > Troubleshooting > Problems with Printing
U326
Paper Does Not Feed Properly/"No Paper" Error Occurs
Check 1: Make sure that paper is loaded.
Loading Paper
Check 2: Make sure of the following when you load paper.
When loading two or more sheets of paper, flip through the paper before loading.
When loading two or more sheets of paper, align the edges of the sheets before loading.
When loading two or more sheets of paper, make sure that the paper stack does not exceed the
paper load limit.
However, proper feeding of paper may not be possible at this maximum capacity depending on
the type of paper or environmental conditions (either very high or low temperature and humidity).
In such cases, reduce the sheets of paper you load at a time to less than half of the paper load
limit.
Always load the paper in portrait orientation, regardless of the printing orientation.
Important
When loading paper in the cassette, slide the paper guide on the front side to align with the
corresponding mark of page size. Load the paper with the print side facing DOWN, load the
paper stack in the center of the cassette, then slide the paper guides to align with the both edges
of the paper stack.
Loading Paper
Check 3: Check to see if the paper you are printing on is not too thick
or curled.
Media Types You Cannot Use
Check 4: Make sure of the following when you load envelopes.
When printing on envelopes, refer to
Once you have prepared the envelopes, load them in portrait orientation. If the envelopes are placed in
landscape orientation, they will not feed properly.
Check 5: Confirm that the media type and the paper size settings
correspond with the loaded paper.
Check 6: Make sure that the inner cover (the cover of the disc tray) is
closed completely.
Paper does not feed properly if the inner cover is even slightly open.
> Paper Does Not Feed Properly/"No Paper" Error Occurs
Loading Paper, and prepare the envelopes before printing.