Table of Contents
Advertisement
Installation
Mounting
1. Turn OFF all power to heating and cooling
equipment.
2. If an existing zone sensor is being replaced:
a. Remove the existing zone sensor from the wall.
b. Disconnect the wires from the existing zone
sensor being careful not to allow them to fall
back into the wall.
3. Carefully pry the sub-base away from the 1040
using a small flat-blade screwdriver. Note that the
tight fit is normal and ensures that the sensor is held
securely to the sub-base when mounted on the wall.
4. Route the wires through the opening on the sub-
base.
page 17
page 17
NOTE: RS1 and ODT terminals are disabled. They
are not compatible with the 1040 zone sensor.
NOTE: RJ-45 plug is disabled. It is not compatible
with the 1040 zone sensor.
ODT
RS1
Thermostat
Wires
Mounting Holes
D
R
B/C
RJ-45
Plug
Optional Mounting Hole
Installation Figure 3
TZON1040 Installation and User Guide
Hide quick links:
Advertisement
Table of Contents
