Remote Controller Setting Guide - Kohler K-4026T-2A-0 Homeowner's Manual

Low voltage alarm
Note: please replace battery in time when the voltage alarm starts.
When M battery alarm icon blinks indicate remote battery is almost used up. Replace battery is required.
Pairing
When powered is on, press and hold dryer button, when indicating LED quick blinks twice. Press and hold power
button on side panel in 20s, release button until one short beep is generated. When LED strip stops blinking
indicates pairing is successful.
Communication between remote control and toilet
When remote moves away from sensing zone, press any button, all LED strip will blinks slowly, starts searching
connection. After successful connection, it will stop blinking.

Remote controller setting guide

Note: Normal function will not be used when initiate any long press setting.
Keep pressing the
times. Then change the setting of B/G/I/J/K by the following requirements.
B - Front Wash...Night LED setting
Press and hold this button to enter Night LED setting, press Front Wash icon to switch dials per activation or
deactivation circulation.
1. Indicating LED lights up above Front Wash icon, indicates Night LED activated and toilet generate one short beep.
2. Indicating LED lights off above Front Wash icon, indicates Night LED deactivated and toilet generate one long beep.
G - Seat Tem...Energy saving setting
Press and hold the button to activate Energy Saving mode, then press Seat Temperature icon to switch dials
per deactivation, dial 1, 2, 3 circulation; when all indicating LED is OFF, Energy Saving mode is deactivated;
when the first LED is ON indicating dial 1 is activated, the second LED is ON indicating dial is 2 activated,
the third LED is ON indicating dial 3 is activated.
1. . When the power save mode is set to a certain period (eg:3 hrs), he product will be under the power save mode during this period, and
will automatically exit the power save mode when time runs out of the preset period.
2. . After the power save mode has been activated, the indicator lig
3. . In the period of power save, the seat will not be heated; Once a
- Flush... Auto Flush setting
Hold and press this button to enter Auto Flush setting, press Flush icon to switch dials per activation or
deactivation circulation.
1. Indicating LED lights up above Rear Wash icon, indicates Auto Flush activated and toilet generate one short beep.
2. Indicating LED lights off above Rear Wash icon, indicates Auto Flush deactivated and toilet generate one long beep.
1396802-T01-C
J
I
A B
key until a short pip is heard, and release the key only after the night lamp flickers for three
K
C D E
in the sensing window shows red color.
function is activated, the power save function stops automatically.
8
L M
F G H
Kohler Co.