Table of Contents
Advertisement
13.
Even though the
A. The seat sensor may not be able to detect you
seat is occupied,
the spray function
does not work.
14.
The hot blower
A. Four minutes after pressing the "Air Speed" icon,
stops during use.
15.
The deodorizing
A. The seat sensor is not detecting the user.
blower feature
doesn't work.
B. Press "STOP"
16.
The remote
A. The battery has been used up.
controller does not
B. The polarity of battery was installed inversely.
work.
17. Flushing function is
A. The "Auto Flushing Function" has been turned
invalid.
B. It will not flush in 60 seconds after having
C. The bidet seat and the toilet are not properly
To troubleshoot this toilet you must first:
Unplug the toilet or turn off the power.
If needed, turn on the water supply.
Plug the toilet back in or turn the power back on.
When the power is turned on, the toilet may flush three times and then function correctly.
IMPORTANT!
No action is needed if this happens.
Note the results (how many times the toilet flushes, whether it operates normally).
Consult the chart above. Perform the recommended action.
1396802-T01-C
depending on the way you are sitting.
blower automatically stops.
off.
pressed the key of "Manual Flushing" on remote
control.
connected.
A. Change the way you sit.
A. Press the "AIR TEMP" button again.
A. See activating the seat information in the
"Operation" section.
B. Same as above.
A. Please replace the battery.
B. Please install the battery correctly.
A. Turn the "Auto Flushing Function" on.
B. Refer to "Toilet Flushing".
C. Check and reconnect.
20
Kohler Co.
Advertisement
Chapters
Table of Contents
