Remote Setting Guide - Kohler K-5402T-0 Homeowner's Manual

M – Wand Move
Press this button to adjust wand move position.
N – Dryer
Press this button the 1
after about 4 min or turn off immediately when press the OFF button.
O – UV Sterilization
Press this button to enter UV sterilization function under unseated status. Icon blink.
P – Water Pressure
Press this button to adjust water pressure dials when front wash or rear wash activated.
Low-voltage Warning
Note: please charge immediately after voltage warning.
• When
停止
Pairing
Note: Pairing process shall only be performed when unseated.
• Press remote top ON button to activate toilet when cover is under normal powered on status. When bottom row of icons
blink for a long time which indicate remote need pairing process.
• Hold remote dryer button, after bottom row of icons quick blinking, toilet operation starts.
•
Hold toilet
•
When the bottom row of icons on remote stop blinking, indicate successful pairing.
Remote to Toilet Communication
• When remote move out from detection area, bottom row of icons on remote will auto flush (indicating searching toilet
signal).When move back to toilet detection area, if toilet is powered on and under normal operation, signal will be auto
connected,icon will stop blinking after successful connection.
Stop Function
• Whenever pressing and holding

Remote Setting Guide

B
G
H
I
J
1302892-T01-B
st
time to activate dryer function after seated; press this button again to adjust dryer dials. Auto stop
button blink, indicate remote internal battery will be exhausted, charging remote is required.
button and button on side panel, release button when heard one short beep.
button, remote shall enter stop mode.
停止
C
cover 便盖
seat 座圈
massage 脉冲/移动
K
D E
spiral 旋转冲洗
L M
50
F
N
O
P
Kohler Co.