M - Position
●
Press +/- (Q+/Q-) to adjust wand position when front or rear wash is activated.
N - Dryer
After sitting, Press this button to activate dryer function after seated, After 4 minutes or so, it stops automatically
or press the Stop key to turn it off immediately.
O - Sanitize
P- Water pressure
●
Under Front or Rear mode, press+/- (Q+/Q-) to adjust gears of water pressure.
O - Parameter adjustment key Q+/Q-:
Only J/F/P/M function is activated, the "+/-"key shall be used to adjust related parameter.
Low voltage alarm
Caution: Please charge in time when the voltage alarm is activated.
●
When the
controller on the base to charge its battery;
Caution:
●When the cover is powered on normally, press the Start key at the top of the remote control. When the icon of
the lowest row flickers for a long time, it means the remote control needs to be
●
Press and hold the Dryer key. When the icon at the lowest row flickers, start the operation at the main unit end.
●
Meanwhile
.
●Once the icon at the lowest row of remote control stops flickering, it means it has been
Communication between remote control and
●If the remote control is moved away from the sensing area, the icon at the bottom row of remote control will
flicker automatically (indicating a searching the signal for the
connected successfully.
Poweroff function
●Press and hold the
Remote Setup Guideline
B
1332624-T01-H
, short press this key to enter UV sterilization function. And the icon will flicker.
button flickers, it indicates that the built-in battery in the remote control is used up. Put the
the
key and
key at any time, the remote controller will enter Power off mode.
H
C
Q-
J
key at side keyboard. Do not release the key until hearing a
).
Then the icon will stop flickering
I
E
G
L
N
K
P
M
F
8
with the main unit.
successfully.
O
Q+
it is
Kohler Co.