Appendix: Regulatory Compliance; Fcc Compliance; Isedc Compliance - Baicells Neutrino-430 Installation Manual

Appendix: Regulatory Compliance

FCC Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. Any
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user
will be required to correct the interference at his own expense.
Warning: This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a minimum
distance of 20 inches (50 cm) between the radiator and your body.

ISEDC Compliance

This device complies with Innovation, Science, and Economic Development
Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference,
and (2) This device must accept any interference, including interference that may cause
undesired operation of the device.
The antenna(s) used for this transmitter must be installed to provide a separation distance of
at least 50 cm from all persons and must not be collocated or operating in conjunction with any
other antenna or transmitter, End-Users must be provided with transmitter operation
conditions for satisfying RF exposure compliance.
28