Table of Contents
Advertisement
Table 3-4: Management Server
Field Name
SSL
Management Server
CloudKey
SNMP
Com2sec
Configuration
Trap Configuration
3.5.5 Configure Quick Settings
Under the BTS Info > Quick Setting window (Figure 3-18) are several important fields you must
configure and/or verify. First, if the operator is using the Baicells CloudCore EPC, you must enter
a fixed PLMN and MME IP address:
•
PLMN = 314030
MME IP = 10.3.0.9 and 10.5.0.9
•
Do not change these settings except when connecting to a Local (private network) EPC or
different vendor's Evolved Packet Core (EPC). Second, you must enter the operator's planned
settings for Band, Bandwidth, EARFCN, Cell ID, PCI, TAC, etc. Some Quick Setting fields such as
Duplex Mode and Frequency will auto-fill based on the eNB hardware model. Make sure the
Cloud EPC field is set to ON when using the Baicells CloudCore. If you are testing the eNB in a
lab environment, turn the power down as low as it will go under the Power Modify field.
NOTE 1: If planning to use CBRS SAS, the SAS vendor will determine some of these
parameters. Refer to the
CPEs do not support SAS.
NOTE
2:
Neutrino-430 does not
For a description of all the Quick Setting fields, refer to the
Description
Enable/Disable Secure Socket Layer (SSL) using ON/OFF
Enter the management server IP address and port number
Operators using the Baicells CloudCore are provided a unique CloudKey
identifier that may be used when configuring CPEs and eNBs. If entered in
this field, when the device is powered on it will immediately associate to
the operator's OMC account. You can find your CloudKey ID when you log
in to the CloudCore. It is displayed in the top bar.
Enabled= OFF/ON
Option available when SNMP option is enabled:
•
Secname
•
Source
Community
•
Option available when SNMP option is enabled:
Community
•
•
Host
SAS Deployment
support SFA = 0.
Guide
for more information. Legacy Gen 1
Baicells CPE Configuration
23
Guide.
Advertisement
Table of Contents
