Table of Contents
Advertisement
NOTE: If the LAN IP address is changed, the eNB will reboot, and you will have to log
in to the GUI again.
Figure 3-13: WAN/LAN
Table 3-1: Internet/WAN
Field Name
Connect Type
MTU
DNS Address 1
DNS Address 2
Enabled
Connect Via
Current IP
Option60
Subnet Mask
Prefix
Gateway
Vlan ID
Description
Used to select the type of connection for the eNB (Copper or Fiber)
Used to specify the size of the largest network layer protocol data unit
that can be communicated in a single network transaction. Range is 500 to
1600.
Used to define the DNS 1 IP address
Used to define the DNS 2 IP address
Used to enable the interface. Four IP addresses are the maximum number
the eNB supports.
Used to select the desired interface protocol: DHCP, Static IP, IPv6 DHCP, or
IPv6 Static IP
The WAN interface IP address
Used to differentiate between different terminal when "Connect Via" is set
to "DHCP"
Used to define subnet mask address if "Connect Via" is set to "Static IP"
Prefix of IPv6 address for WAN interface if "Connect Via" is set to "IPv6
Static IP"
Used to define gateway address if "Connect Via" is set to "Static IP"
Used to configure more IP addresses for the WAN interface through the
VLN when there is a need to transmit multi-types of data.
19
Advertisement
Table of Contents
