Location & Environment; Table 2-2: Leds; Table 2-3: Interfaces; Table 2-4: Environment Specifications - Baicells Neutrino-430 Installation Manual

Table 2-2: LEDs

LED Color Status
Steady on
PWR Green
OFF
Steady on
RUN Green Fast flash: 0.125s on, 0.125s off
Slow flash: 1s on, 1s off
ACT Green OFF
Steady on
ALM Red Fast flash: 0.125s on, 0.125s off
Slow flash: 1s on, 1s off

Table 2-3: Interfaces

Interface Name
PWR
GPS
WAN/PoE+
OPT
2.3 Location & Environment
The Neutrino-430 can be installed on a ceiling or a wall. For the best signal coverage, place the
eNB in an unobstructed location. In addition to network planning, when determining where to
place the eNB, you need to consider the best location for signal coverage. Avoid locating the
eNB in areas where there may be extreme temperatures, harmful gases, unstable voltages,
volatile vibrations, loud noises, flames, explosives, or electromagnetic interference (e.g., large
radar stations, transformer substations). Avoid areas prone to impounded water, soaking,
leakage, or condensation. Environmental specifications are shown in Table

Table 2-4: Environment Specifications

Item
Operating Temperature
Storage Temperature
Humidity
Atmospheric Pressure
Description
12V DC power supply interface
Port for optional external GPS antenna, N-female connector
Gigabit Ethernet and PoE+ interface, used for debug and power supply.
Optical fiber interface, connect to external transmission network, used
for data backhaul.
Description
-5°C to 40°C
-10°C to 50°C
5% to 95%
70 kPa to 106 kPa
Description
Power is on
No power supply
Power is on
Data is transmitting
The cell has been activated
Reserved
Reserved
S1 alarm
Other alarms
10
2-4.