Configure Carrier Setting; Figure 3-18: Quick Setting - Baicells Neutrino-430 Installation Manual

Indoor 4x250mw two-carrier tdd enodeb

Hide thumbs Also See for Neutrino-430:

Table of Contents

3.5.6 Configure Carrier Setting

Reference:

Carrier Aggregation & Dual Carrier (Split Mode) Configuration Guide

The Carrier Setting menu is used only in the

two-carrier Neutrino-430 eNB

(Figure 3-19). You

can set the eNB to run as a single carrier, as two combined carriers using Carrier Aggregation

(CA), or as two independent carriers using Dual Carrier (DC)/split mode, depending on which

licenses you have purchased. Single carrier (no CA) means only Cell 1 will operate and use only

2 RF ports instead of 4. Operators may need to use this mode if they have limited spectrum or

are planning to change to CA or DC mode at a later time when more capacity is needed for the

coverage area.

At the Carrier Mode field, if you select Dual Carrier, the Carrier Aggregation check box is

automatically checked for the two carriers to operate in CA mode. If you want the eNB to

operate in DC/split mode, uncheck the Carrier Aggregation Enabled check box.

Whenever you change the carrier setting, you must reboot the eNB for the change to take

effect.

Table of Contents