3.2 Install eNB on Ceiling or Wall
The eNB mounting bracket is assembled in manufacturing before packing. The only action
required by the installer is to fix the assembly to the ceiling or wall.
Follow the steps below to install the Neutrino-430 eNB on the ceiling or wall.
Caution:
• Ceiling thickness must be at least 18 mm and must bear a weight of at
least 5 kg.
• If the ceiling is made of drywall or gypsum, it must be reinforced
before installation to ensure the eNB is secure.
1. Fit the installation bracket on the ceiling or wall, as shown in Figure 3-2. Mark the
drilling locations using a pencil or marker and drill four holes at the marked locations.
Figure 3-2: Mark and Drill the Holes
2. Install the expansion pipes and the screws, as shown in Figure 3-3.
Figure 3-3: Install Expansion Pipes and Screws
3. Slide the eNB along the arrow to fix it on the bracket (Figure 3-4).
Figure 3-4: Fix the eNB to the Bracket
12