Error 2; Error Displays; Troubleshooting - Clarion XDZ716 Owner's Manual

9. TROUBLESHOOTING

Problem
Cause
Power does not Fuse is blown.
turn on.
(No sound is
produced.) Incorrect wiring.
No sound output Power antenna lead is
when operating shorted to ground or
the unit with
excessive current is required
amplifiers or for remote-on the amplifiers
power antenna or power antenna.
attached.
Nothing happens The microprocessor has
when buttons are malfunctioned due to noise,
pressed. etc.
Display is not
accurate.
DCP or source unit
connectors are dirty.
Compact disc Another compact disc is
cannot be loaded.
already loaded.
Sound skips or is Compact disc is dirty.
noisy.
Compact disc is heavily
scratched or warped.
Sound is bad Water droplets may form on
directly after the internal lens when the
power is turned car is parked in a humid
on. place.
32
XDZ716
Measure
Replace with a fuse of the same amperage. If the
fuse blows again, consult your store of purchase.
Consult your store of purchase.
1. Turn the unit off.
2. Remove all wires attached to the power antenna
lead. Check each wire for a possible short to
ground using an ohm meter.
3. Turn the unit back on.
4. Reconnect each amplifier remote wire to the
power antenna lead one by one. If the amplifiers
turn off before all wires are attached, use an
external relay to provide remote-on voltage
(excessive current required).
Turn off the power, then press the RELEAS button 1
and remove the DCP.
Press the reset button for about 2 seconds with a thin
rod.
Reset button
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol.
Eject the compact disc before loading the new one.
Clean the compact disc with a soft cloth.
Replace with a compact disc with no scratches.
Let dry for about 1 hour with the power on.

10. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
Error Display Cause

ERROR 2

A CD is caught inside the CD deck and is
not ejected.
ERROR 3 A CD cannot be played due to scratches,
etc.
ERROR 6 A CD is loaded upside-down inside the CD
deck and does not play.
ERROR 2 A CD inside the CD changer is not loaded.
ERROR 3 A CD inside the CD changer cannot be
played due to scratches, etc.
ERROR 6 A CD inside the CD changer cannot be
played because it is loaded upside-down.
ERROR H Displayed when the temperature in the
MD changer is too high and playback has
been stopped automatically.
ERROR 2 An MD inside the MD changer is not
loaded.
ERROR 3 An MD inside the MD changer cannot be
played due to scratches, etc.
ERROR 6 An MD inside the MD changer cannot be
played because it is loaded upside-down.
Displayed when a non-recorded MD is
loaded in the MD changer.
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
Measure
This is a failure of CD deck's mechanism
and consult your store of purchase.
Replace with a non-scratched,
non-warped-disc.
Eject the disc then reload it properly.
This is a failure of CD changer's mecha-
nism and consult your store of purchase.
Replace with a non-scratched, non-warped
disc.
Eject the disc then reload it properly.
Lower the surrounding temperature and
wait for a while to cool off MD changer.
This is a failure of MD changer's mecha-
nism and consult your store of purchase.
Replace with a non-scratched, non-warped
disc.
Eject the disc then reload it properly.
Load a pre-recorded MD in the MD
changer.
33
XDZ716