Table of Contents
Advertisement
7-9.
VCS-700, Video Selector
7-9-1
Front panel
Rear Panel
a POWER switch and indicator
a
a
a
This switch turns the power ON and OFF. The indicator
illuminates when power is switched on.
b
b PIX1 through PIX6 INPUT (picture monitor 1
b
b
through 6 inputs) connectors (BNC type)
Accept video signals for a picture monitor. Connect
each of these connectors to the PIX2 OUTPUT
connector on the CCU-700A/700AP/550D/550DP
Camera Control Unit. The signal loss of a connecting
cable up to about 30 metres (99 feet) long can be
compensated for with the switch on the internal board.
For details, refer to the system manual.
c CHARACTER INPUT connectors (BNC type)
c
c
c
Accept character signals. The input signal is mixed
with the signal output from the PIX OUTPUT connector.
Connect to the CHARACTER connector on the CNU-
700 Camera Command Network Unit. When using two
VCS-700 units, connect either of these connectors to
the CHARACTER INPUT connector on a second VCS-
700. When a loop connection is not made, be sure to
terminate with 75 ohms.
d
d PIX A INPUT (picture monitor A input) connector
d
d
(BNC type)
Connect to the PIX A OUTPUT connector on a second
VCS-700 when using two or more VCS-700 selectors.
e PIX A OUTPUT (picture monitor A output)
e
e
e
connector (BNC type)
Supplies a video signal for a picture monitor. Select the
output signal with the camera select buttons on an
MSU-700A/750 or by command from the I/O PORT
connector on the VCS-700 Video Selector. When using
two or more VCS-700 units, connect this connector to
the PIX A INPUT connector on each subsequent VCS-
700, and a picture monitor to the PIX A OUTPUT
connector on the final VCS-700 in the series
connection.
Front and Rear Panels
1 POWER switch and indicator
POWER
3 CHARACTER INPUT connectors
2 PIX 1 through PIX 6 INPUT connectors
8 WF 1 through WF 6 INPUT connectors
9 WF A INPUT connector
q; WF A OUTPUT connector
qa WF B OUTPUT connector
VIDEO SELECTOR
4 PIX A INPUT connector
5 PIX A OUTPUT connector
6 PIX B OUTPUT connector
7 SYNC OUT connector
qf I/O PORT connector
qd REMOTE connector
qs WF MODE connector
f PIX B OUTPUT (picture monitor B output)
f
f
f
connector (BNC type)
Supplies the same video signal for a picture monitor as
the PIX A OUTPUT connector. The signal loss of a
connecting cable up to about 100 metres (330 feet)
long can be compensated for with the switch on the
internal board. When you connect a picture monitor
using a long connecting cable, connect it to this
connector. When using two or more VCS-700 units
connected in series, connect a picture monitor to the
PIX B OUTPUT loop connector on the VCS-700 whose
PIX A OUTPUT connector is not used for series
connection.
Chapter 7 Location and Function of Parts and Controls
BVP-E10 Series Product Information Manual
qg -AC IN connector
79
Advertisement
Table of Contents
