Rack Mounting Of System Equipment - Sony BVP-E10 Series Product Information Manual

2-7.

Rack Mounting of System Equipment

19-inch size equipment
The CCU-700A/ 700AP/ 900/ 900P Camera Control
Unit, CNU-700 and CNU-500 Camera Command
Network Units, and VCS- 700 Video Selector can be
mounted in a 19-inch standard EIA rack. These units
either mount directly into the rack or with optional slide
rails. These slide rails allow the unit to be easily pulled
out from the rack and are recommended if you
intended to pull out the unit frequently.
Warning for Safety Purpose: It takes two or more people to
mount a unit into a rack. Mounting the unit into a rack by
yourself can cause back or other injuries.
Mounting the unit directly to the rack
Fix the unit to the rack using the rack mount bracket of
the unit. Daily maintenance is easy with the unit
mounted with this method.
Universal-type rack
Wide-type rack
In addition units should be supported with L-brackets
mounted at each side of the rack
CCU-550D/ 550DP
The two CCU-550D/ 550DP can be mounted in parallel
in a 19-inch EIA standard rack by using the rack mount
adapter RMM-301 (optional). (Three-unit height)
Installation
1.
Secure the RMM-301 in the 19-inch EIA standard
rack with the four B5 screws (6 mm or longer).
12.7
15.9
15.9
12.7
12.7
31.75
12.7
57.2 mm
B5 screw
(6 mm or longer)
RMM-301
B5 screw
(6 mm or longer)
2.
Secure the unit with the supplied four screws (B4 x
6) and the four washers.
W4
W4
B4 x 6
B4 x 6
Warning
• If the rack falls due to the weight of the equipment, it
may cause death or major injury. To prevent the rack
from falling or moving, be sure to fix the rack to the
floor.
• If the rack falls, death or serious injury may result.
When attaching the unit, be sure to fix the rack to the
floor and be careful not to attach at a height of 1.2 m
or higher from the floor.
Caution
• Use the specified rack mount adapter. If not, injury
could occur by drop of the unit because strength of
the shelf board is not enough.
• Mount the unit with more than two persons. A one
man job may cause injury.
• Be careful not to catch your finger or hand in the rack
mount rail.
BVP-E10 Series Product Information Manual
Chapter 2 A Total System
29