Table of Contents
Advertisement
d ND filter selector
d
d
d
Selects the desired ND filter.
Filter No.
1
2
3
4
e CC (colour temperature conversion) filter
e
e
e
(BVPE10WS/ E10WSP only)
Selects the desired CC filter suitable for the lighting
conditions. Note that in the BVP-E10/E10P cameras,
electronic colour temperature correction is used
instead of an optical filter.
Filter No.
A
B
C
D
f WHITE BAL (white balance memory select)
f
f
f
switch
Selects the white balance adjustment method and
memory cell to store the adjusted value.
PRESET: White balance is automatically adjusted
to the preset value for the colour temperature of
3,200K.
A or B: Memory cell A or B is selected.
g OUTPUT/DCC (output signal select/auto knee)
g
g
g
switch
Selects an output signal supplied to a VTR, viewfinder,
and video monitor (colour-bar signals or camera
picture). When a camera picture is selected, the auto
knee function can be activated.
BARS/OFF: Colour-bar signals are output, and the
autoknee circuit does not function.
CAM/OFF: A camera picture is output, but the auto-
knee circuit does not function.
CAM/ON: A camera picture is output, and the auto-
knee circuit functions.
h GAIN switch
h
h
h
Selects the appropriate video gain (Low, Medium,
High) according to the illumination of the subject to be
shot. The actual gain values for positions L, M, and H,
are set with the OPERATION Menu.
i VTR switch
i
i
i
When a portable VTR is connected to the camera via
the CA-530/570/570P/950/950P Camera Adaptor, the
VTR starts recording as follows:
SAVE: Power-save position for recording.
Recording starts a few seconds after the VTR
START button is pressed. A newly recorded picture
may not smoothly be connected to the previously
recorded part.
STBY (standby): Recording starts immediately
upon pressing the VTR START button.
Note:
The WHITE BAL, OUTPUT/DCC, GAIN, and VTR
switches do not function when the camera is
connected to a Camera Control Unit (CCU), RCP or
Remote Control Unit (RM).
j STATUS/CANCEL switch
j
j
j
STATUS: Displays the setting status of the camera
on the viewfinder screen when the switch is set to
Filter
this position after setting the DISPLAY switch to ON.
CANCEL: Cancels the selection made by the
Clear
MENU SELECT knob and restores the previously
1/4ND
selected menu item.
1/16ND
k DISPLAY switch
k
k
k
1/64ND
Used for displaying the current status of the camera,
settings of format and assignable buttons, and menu
on the viewfinder screen.
ON: Display function activated
OFF: Display function not activated
MENU: A screen for setting the displaying items
and functions appears.
l
l
l
l Memory Stick slot
Insert a Memory Stick to store file data.
Filter
Cross filter
m
m CA lock screw
m
m
3,200K (Clear)
Tighten the screw to secure the CA-530/ 570/5 70P/
950/ 950P Camera Adaptor to the camera.
4,300K
6,300K
n LOCK knob
n
n
n
Locks the viewfinder after adjusting the position in the
front-to-rear direction together with the viewfinder lock
lever.
o
o Viewfinder lock ring
o
o
Locks the viewfinder after adjusting the position side to
side.
p
p
p
p TEST OUT connector (BNC type)
Supplies the signal selected with the menu operation
or the remote control panel.
Chapter 7 Location and Function of Parts and Controls
BVP-E10 Series Product Information Manual
59
Advertisement
Table of Contents
