Hand Strap Installation - Iwatsu Omegatrek PS6 Owner's Manual

• Getting Started
NOTES:
• When the battery is fully charged, the Battery Charging Status Lamp
changes from red to green.
• The Portable Station and the charger may feel warm to the touch. This is
normal.
• You cannot turn the power on while the battery is being charged. Pick up
the Portable Station from the charger before turning the power on.
• If you place the Portable Station in the charger while the power is still on,
charging the battery may take loner than usual.
• When you use the Portable Station for the first time, or if you have not
used it for a long time, leave the Portable Station in the charger for at least
seven hours.
• If the Portable Station or the charger is wet, wipe it with a dry cloth before
charging.
• The operating temperature is 41°F to 95°F. The battery may not be charged
properly if the temperature is outside the range.
• If the battery is not being charged properly, the Charge lamp flashes red.
Pick up the PS6 Portable Station and place it back in the charger. This
indication will also occur if the battery needs to be replaced.
• If the level of battery charge becomes too low, the Charge lamp may not
illuminate.

Hand Strap Installation

To attach the hand strap, follow these steps:
1. Put the thin string of the hand strap through the hole in the Portable Station
as shown in the following diagram.
2. Put the other end through the thin string and pull it tight.
10 • Omegatrek Owner's Manual