Table of Contents
Advertisement
Chapter 2
Getting Started
You Cannot Use Your Portable Station
When:
1. You do not see the Antenna icon. (Refer to LCD Display).
When the Portable Station is outside the service area or receiving
a weak signal in the service area, you cannot place or receive
phone calls. Go to an area where the Portable Station receives a
stronger signal. The Antenna icon will appear when you enter an
area with a stronger signal.
2. You press a key and see KEY LOCK on the display. The Key
Lock feature is enabled to prevent unintentional key operations.
Disable the Key Lock feature.
3. You press a key and see DIAL LOCK on the display. The Dial
Lock feature is enabled to prevent unauthorized outgoing calls.
Disable the Dial Lock feature.
4. The outline of the Battery icon is blinking. The battery charge
has become too low. You will also hear a slow warning tone.
Place the Portable Station into the charger to recharge the battery.
Battery Installation
1. Plug the battery into the connector. The connector is a small, white input
device located on the back of the Portable Station within the battery com-
partment. You must gently slide the battery cover down and off to access
the compartment. The connector should be installed with the red (+) wire
to the left and the black (-) wire to the right (see diagram below).
2. Place the battery snugly into the compartment.
Omegatrek Owner's Manual • 7
Advertisement
Table of Contents
