Grizzly G0513 Series Owner's Manual page 38

4. Loosen the guide block cap screw shown in
Figure 50.
0.004"
Gap
Blade
Guide
Block
Figure 50. Back of upper blade guides.
5.
By hand, slide the guide block to position the
blade guides approximately 0.016" behind
the teeth gullets (see Figure 51), then re-
tighten the guide block cap screw to secure
the setting.
0.016"
Gap
Tooth
Gullet
Figure 51. Correct guide alignment behind the
teeth gullets.
-36-
Blade
Guides
Guide Block
Cap Screw
Blade
Guide
Make sure that the blade teeth will not con-
tact the guides when the blade is against the
rear support bearing during the cut or the
blade teeth will be damaged.
The lower blade guides are adjusted in the same
manner as the upper blade guides. However,
some controls are different. Refer to Figure 52 to
become familiar with these controls.
Thumb
Screw
Guide
Block
Figure 52. Lower blade guide controls.
G0513 Series Bandsaws (Mfd. Since 08/22)
Guide Block
Cap Screw