Grizzly G0513 Series Owner's Manual page 14

Grounding Requirements for 110V: The plug
specified under "Circuit Requirements for 110V
Operation" on the previous page has a grounding
prong that must be attached to the equipment-
grounding wire inside the specified power cord.
The plug must only be inserted into a matching
receptacle (see Figure 6) that is properly installed
and grounded in accordance with all local codes
and ordinances.
L5-30 GROUNDED
LOCKING
RECEPTACLE
Neutral
L5-30
LOCKING
PLUG
Hot
Grounding Prong
is Hooked
Figure 6. Typical L5-30 plug and receptacle.
This machine is equipped with a power cord that
has an equipment-grounding wire and a grounding
plug. Only insert plug into a matching receptacle
(outlet) that is properly installed and grounded in
accordance with all local codes and ordinances.
DO NOT modify the provided plug!
Improper connection of the equipment-grounding
wire can result in a risk of electric shock. The
wire with green insulation (with or without yellow
stripes) is the equipment-grounding wire. If repair
or replacement of the power cord or plug is nec-
essary, do not connect the equipment-grounding
wire to a live (current carrying) terminal.
Check with a qualified electrician or service per-
sonnel if you do not understand these grounding
requirements, or if you are in doubt about whether
the tool is properly grounded. If you ever notice
that a cord or plug is damaged or worn, discon-
nect it from power, and immediately replace it with
a new one.
-12-
No adapter should be used with plug. If
plug does not fit available receptacle, or if
machine must be reconnected for use on a
different type of circuit, reconnection must
be performed by an electrician or qualified
service personnel, and it must comply with
all local codes and ordinances.
Extension Cords
We do not recommend using an extension cord
with this machine. If you must use an extension
cord, only use it if absolutely necessary and only
on a temporary basis.
Extension cords cause voltage drop, which can
damage electrical components and shorten motor
life. Voltage drop increases as the extension cord
size gets longer and the gauge size gets smaller
(higher gauge numbers indicate smaller sizes).
Any extension cord used with this machine must
be in good condition and contain a ground wire
and matching plug/receptacle. Additionally, it must
meet the following size requirements:
Minimum Gauge Size at 220V .............14 AWG
Minimum Gauge Size at 110V ..............12 AWG
Maximum Length (Shorter is Better).......50 ft.
Voltage Conversion
Models G0513, G0513A40, & G0513X2
The voltage conversion MUST be performed by
a qualified electrician. To perform the voltage
conversion, install the correct plug and rewire the
motor to the new voltage, according to the pro-
vided wiring diagram. If the diagram included on
the motor conflicts with the one in this manual, the
motor may have changed since the manual was
printed. Use the diagram provided on the motor.
G0513 Series Bandsaws (Mfd. Since 08/22)