Grizzly G0513 Series Owner's Manual page 25

The table is heavy and requires two people
to lift it onto the trunnions. Remove the saw
blade to make table installation easier.
8. Models G0513 and G0513A40: Secure table
to trunnions, as shown in Figure 23, with (4)
M8-1.25 x 16 hex bolts, 8mm lock washers,
and 8mm flat washers.
Models G0513X2 G0513X2BF: Secure table
to trunnions with (4) M8-1.25 x 25 hex bolts,
8mm lock washers, and 8mm flat washers.
Trunnions
Figure 23. Mounting the table.
9.
Re-install saw blade.
G0513 Series Bandsaws (Mfd. Since 08/22)
Models G0513, G0513A40 & G0513X2
10. Attach rear rail to table with (2) M6-1 x 16 cap
screws, as shown in Figure 24.
11. Attach front rail with (2) M6-1 x 20 hex bolts,
6mm lock washers, and 6mm flat washers, as
shown in Figure 24.
Rear Rail
x 4
12. Install (1) M8-1.25 hex nut on fence handle,
then thread handle into fence assembly, as
shown in Figure 25. Tighten hex nut against
fence pivot block to secure handle.
Hex
Nut
Figure 25. Example of handle installed on fence
x 2
Front Rail
Figure 24. Rail installation.
Pivot Block
assembly.
x 2
-23-