Mounting The Airmotiv E2 - Emotiva airmotiv + User Manual

AIRMOTIV SPEAKERS

Mounting the Airmotiv E2+

Airmotiv E2+ surround speakers are each supplied with a custom heavy duty steel mounting
bracket. Affixed to the rear panel of each Airmotiv E2+ are four mounting screws with raised
head-studs, each surrounded on the rear surface of the speaker by a rubber pad.
The mounting bracket should be secured to your wall using the appropriate mounting hardware
for your wall construction. Once the mounting bracket is securely fastened to the wall, the speaker
is mounted to it by pressing the speaker back against the bracket so that the four screws enter the
mounting holes in the bracket, then sliding the speaker downwards so that the screw studs in the
speaker fully engage the keyways in the mounting bracket. (You may find that you need to loosen
the mounting screws on the rear of the Airmotiv E2+'s in order to ensure a snug but not forced fit
with the bracket).
To remove the speaker for cleaning or to adjust the switches, simply slide the speaker upwards,
then pull it forward away from the wall.
7-7/8"
7/16" 1/16"
MOUNTING BRACKET
4-3/16"
REAR OF
AIRMOTIV E2
8-1/16"
Note six (6) wall bracket mounting holes.
Page 25