Agilent Technologies HDMP-3001 Datasheet page 86

ADDR = 0x19C-F: TX FIFO Underrun Error
ADDR
Bit name 0x19C
0x19D
0x19E
0x19F
R/W
Value
after
reset
TX_FIFO_UR_ERR is the TX_FIFO Underrun Error counter. It is non-resetable except that a hard or soft
reset will clear it. After reaching its max value the counter starts over from zero again.
This counter is incremented each time there is a FIFO underrun and hence a frame is discarded.
ADDR = 0x1A0: Ethernet Transmit Interrupt Event
Bit 7 Bit 6
Bit name Reserved Reserved
R/W — —
Value 0 0
after
reset
Bits 7-4: Reserved
Bit 3: NEW_TX_FIFO_UR_ERR is set whenever a new TX FIFO Underrun Error occurs and is cleared
when a 1 is written to this bit. For more information, refer to the register definition of TX FIFO
Underrun Error counter.
Bit 2: NEW_TX_FIFO_OF_ERR is set whenever a new TX FIFO Overflow Error occurs and cleared
when a 1 is written to this bit. For more information, refer to the register definition of TX FIFO
Overflow Error counter.
Bit 1: NEW_TX_ER_ERR is set whenever a new TX_ER Error occurs and cleared when a 1 is written
to this bit. For more information, refer to the register definition of TX_ER Error counter.
Bit 0: NEW_TX_MII_ALIGN_ERR is set whenever a new TX MII Alignment Error occurs and cleared
when a 1 is written to this bit. For more information, refer to the register definition of TX MII
Alignment Error counter.
86
Bit 7 Bit 6
TX_FIFO_UR_ERR [7:0]
TX_FIFO_UR_ERR [15:8]
Fixed 0
Fixed 0
RO
0
Bit 5 Bit 4
Reserved Reserved
— —
0 0
Bit 5 Bit 4 Bit 3
Bit 3 Bit 2
NEW_TX_ NEW_TX_
FIFO_UR_ FIFO_OF_
ERR ERR
R/W R/W
W1C W1C
0 0
Bit 2 Bit 1 Bit 0
Bit 1 Bit 0
NEW_TX_ NEW_TX_
ER_ERR MII_ALIGN
_ERR
R/W R/W
W1C W1C
0 0