Agilent Technologies HDMP-3001 Datasheet page 51

ADDR = 0x005: PHY Address[4:0]
Bit 7 Bit 6
Bit name Reserved Reserved
R/W — —
Value 0 0
after
reset
Bits 7-5: Reserved
Bits 4-0: PHY_ADDR specifies the PHY address for the HDMP-3001 chip. The chip uses the PHY address to
respond to the Management Entity when addressed through the MDIO port.
ADDR=0x006: Interrupt Status
Bit 7 Bit 6
Bit name Reserved Reserved
R/W — —
Value 0 0
after
reset
Bits 7-2: Reserved
Bit 1: RX_APS_INT is set to indicate at least one of the RX_K1_D, RX_K2_D, or K1_UNSTAB_D is set
and unmasked. This condition asserts the APS_INT pin unless RX_APS_INT_MASK is set.
Bit 0: SUM_INT is set to indicate an active non-masked alarm from a non-masked alarm group. This
condition asserts the INTB pin unless SUM_INT_MASK is set.
List of Interrupt Groups: TOH_D_SUM, PTR_D_SUM, PATH_D_SUM, and EoS_D_SUM
51
Bit 5 Bit 4
Reserved PHY_ADDR[4:0]
— R/W
0 0x1B
Bit 5 Bit 4
Reserved Reserved
— —
0 0
Bit 3 Bit 2
Bit 3 Bit 2
Reserved Reserved RX_APS_
— —
0 0
Bit 1 Bit 0
Bit 1 Bit 0
SUM_INT
INT
R R
0 0