Table of Contents
Advertisement
1
2
5mm
3
INSTALL COOKTOP – PROUD
Turn the cooktop upside down
on a protective cover.
Apply adhesive foam seal around
the glass overhang, 5mm from
the edge of the glass.
Ensure the adhesive side facing is
down to form a continuous seal
around the cooktop.
Trim the excess sealing
material using a sharp cutter
or trimmer knife.
Take care not to damage
the benchtop.
Optional 62mm
extender block
4
5
Filter housing
Ducting
6
*When installing in a 600mm deep cabinet, extension blocks are not required. If installing into a 700mm deep cabinet, both
supplied extension blocks should be used.
Slot the two filter housing
components together. If using the
supplied 62mm extension blocks*,
add between the two filter
housing components as required.
Fit to the rear of the cooktop.
Attach the four side clips
to the cooktop chassis.
Ensure the clips are
oriented correctly.
Align vertical ducting to the
outlet to the cooktop before
rotating and lowering it into
the cutout.
Tape the ducting to secure.
13
Advertisement
Table of Contents
