Fisher & Paykel OR30SDPWGX1 Instructions Manual page 14

Problems on Starting and During the
Self Cleaning Cycle
1. "door" (flashing) Appears on the
Programmer Display
The function selector has been turned to the self
cleaning position with the oven door open or not
https://producthelp.fisherpaykel.com/us/Cook/Ranges/Dual_Fuel/OR30SDPWGX1/User_Guide_OR30SDPWGX1/06_how_to...
of the programmer and then turn the
temperature dial to the right to increase the
time or to the left to reduce it. During the setting
"P" is not shown on the display.
4. Press
on the programmer to start the cycle. This
combined confirmation operation offers greater
safety when there are children; in fact turning
the dial to the self cleaning function has no
effect if of the programmer is not then pressed.
The programmer display reads PH:MM
(H:MM=self cleaning time where H=hours and
MM=minutes) and the door is locked after some
seconds. On the control panel the door locked
pilot light lights up to indicate that the door is
locked.
The self cleaning cycle starts immediately (the symbol
lights up) and is completed in the programmed
time.Throughout the self cleaning cycle the programmer
displays the time (hours and minutes) remaining until the
cycle is finished.
The self cleaning cycle only
starts with the oven door
closed. If the door is open or
not closed properly ("door"
flashes on the display) the
oven CANNOT perform the
self cleaning cycle; electronic
safety devices prevent the self
cleaning cycle from starting.
Updated: Sat, 15 Jan 2022 21:49:42 GMT
Powered by
14