Copying Memory Contents - Icom IC-R20 Instruction Manual

6
MEMORY CHANNELS

■ Copying memory contents

This function transfers a memory channel's contents to VFO
(or another memory channel). This is useful when searching
for signals around a memory channel frequency and for re-
calling the offset frequency, subaudible tone frequency etc.
D Memory➪VFO
q Select the memory channel to be copied.
➥ Push [MR S.MW] to select memory mode, then rotate
[R-DIAL] to select the desired memory channel.
• Select the bank channel with [BAND] and [R-DIAL], if desired.
wPush [MR S.MW] for 1 sec. to select the select memory
write condition.
• 1 short and 1 long beep sound.
• "µ µ
" indicator blinks.
e Push [VFO MHz] to select "VFO."
• Rotate [R-DIAL] can also select "VFO."
rPush [MR S.MW] for 1 sec. to write the selected channel
contents to VFO mode.
• Returns to VFO mode automatically.
[EXAMPLE]: Copying channel 20 to 51.
Select memory
MR
S.MW
channel
-DUP -DUP
MODE
145 870
√
31
MR
Push for 1 sec.
S.MW
TSQL TSQL AFC FM FM
145.870
ANL
FM
-BANK BANK-:----
-BNAME: -BNAME:
PSKIP
-MNAME: MNAME:
µ 020
-SKIP SKIP-:OFF
>CLEAR CLEAR
Pushing [MR S.MW] for 2 sec. at the step w, will also
copy the memory contents to VFO. In this case, the steps
e and r are not necessary.
D Memory➪memory
q Select the memory channel to be copied.
➥ Push [MR S.MW] to select memory mode, then rotate [R-
DIAL] to select the desired memory channel.
wPush [MR S.MW] for 1 sec. to select the select memory
write condition.
• 1 short and 1 long beep sound.
• "µ µ
" indicator blinks.
• Do not hold [MR S.MW] for more than 1 sec. otherwise the
memory contents will be copied to VFO.
e Rotate [R-DIAL] to select the target memory channel.
r Push [MR S.MW] for 1 sec. again to copy.
Rotate
FM
-DUP -DUP TSQL TSQL
---------------- ----------------
µ
. 020 020
:---- -BANK BANK-:----
-BNAME: -BNAME:
-MNAME: MNAME:
:OFF -SKIP SKIP-:OFF
>CLEAR CLEAR
MR
Push for 1 sec.
S.MW
-DUP -DUP
MODE FM
145 870
µ
. 051 051
:----
√
:OFF
TSQL TSQL AFC
ANL
PSKIP
µ 051