Icom IC-R20 Instruction Manual page 67

D D Dial speed acceleration
The dial speed acceleration automatically speeds up the tun-
ing dial speed when rotating [R-DIAL] rapidly.
• OFF : The dial speed acceleration is turned OFF.
• ON : The dial speed acceleration is tuned ON.
(default)
DIAL-SPEED-UP
----------------
>OFF
-ON
The acceleration OFF
D D Monitor key action
The monitor key, [SQL], can be set as a 'sticky' key. When
set to the sticky condition, each push of [SQL] toggles the
monitor function ON and OFF.
• PUSH : Pushing and holding [SQL] to monitor the fre-
quency. (default)
• HOLD : Push [SQL] to monitor the frequency and push
again to cancel it.
MONITOR
----------------
>PUSH
-HOLD
Push to monitor
DIAL-SPEED-UP
----------------
-OFF
>ON
The acceleration ON
MONITOR
----------------
-PUSH
>HOLD
Push and hold [SQL] to monitor
D D Auto power OFF
The receiver can be set to automatically turn OFF after a
specified period has past.
30 min., 1 hour, 1.5 hours, 2 hours, BUSY and OFF (default)
can be specified. The specified period is retained even when
the receiver is turned OFF by the auto power OFF function.
To cancel the function, select "OFF" in this set mode.
• 30–120: The receiver automatically turns OFF (with a
beep) after a specified period from last key op-
eration.
• BUSY : The receiver automatically turns OFF (with a
beep) after 3 minutes from last key operation or
signal reception.
AUTO-POWER-OFF
----------------
-OFF
>30MIN
-60MIN
-90MIN
-120MIN
-BUSY
30 min. timer
10
SET MODE
AUTO-POWER-OFF
----------------
-OFF
-30MIN
-60MIN
-90MIN
>120MIN
-BUSY
2 hrs. timer
10
54