I Select Memory Scan Operation; I Setting Select Memory Channels - Icom IC-756PROII Instruction Manual

7
SCANS

I Select memory scan operation

q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Select memory mode.
e Push [(F-5)SCAN] to select the scan screen.
qr.qot.pp
r Set [RF/SQL] open or closed.
• See p. 57 for scan condition.
• If the [RF/SQL] control function is set as "AUTO," the
squelch is always open in SSB, CW and RTTY modes.
See pgs. 3, 69 for details.
t Push [(F-1)MEMO] to start the memory scan.
• Decimal points blink while scanning.

I Setting select memory channels

q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Select memory mode.
e Push [(F-5)SCAN] to select the scan screen.
qr.qot.pp
r Select the desired memory channel to set as a se-
lect memory channel.
60
qw pp
qr.wpt.pp
qw pp
qr.wpt.pp
y Push [(F-3)SELECT] to start select memory scan;
push [(F-3)SELECT] again to return to memory
scan, if desired.
qr.qot.pp
qr.wpt.pp
u When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
i To cancel the scan, push [(F-1)MEMO].
2 or more memory channels must be designated
as select memory channels for select memory
scan to start.
t Push [(F-3)SELECT] to set the memory channel
as a select memory or not.
" " appears for select memory channels.
qr.qot.pp
qr.wpt.pp
y Repeat steps r to t to program another memory
channel as a select memory channel, if desired.
u Push [EXIT/SET] to exit the scan screen.
Select memory channels can also be set in the
memory channel screen. (p. 52)
qw pp
qw pp