I Programmed Scan Operation; I ∂F Scan Operation - Icom IC-756PROII Instruction Manual

7
SCANS

I Programmed scan operation

q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Select VFO mode.
e Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
r Push [(F-5)SCAN] to select the scan screen.
t Set [RF/SQL] open or closed.
• See previous page for scan condition.
• If the [RF/SQL] control function is set as "AUTO," the
squelch is always open in SSB, CW and RTTY modes.
See pgs. 3, 69 for details.
I ∂ ∂ F scan operation
q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Select VFO mode or a memory channel.
e Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
r Push [(F-5)SCAN] to select the scan screen.
t Set [RF/SQL] open or closed.
• See previous page for scan condition.
• If the [RF/SQL] control function is set as "AUTO," the
squelch is always open in SSB, CW and RTTY modes.
See pgs. 3, 69 for details.
y Set the ∂F span by pushing [(F-4)∂F SPAN].
• ±5 kHz, ±10 kHz, ±20 kHz, ±50 kHz, ±100 kHz,
±500 kHz and ±1000 kHz are selectable.
u Set center frequency of the ∂F span.
58
y Push [(F-1)PROG] to start the programmed scan.
• Decimal points blink while scanning.
qr.qot.pp
qr.wpt.pp
u When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
i To cancel the scan, push [(F-1)PROG].
If the same frequencies are programmed into the
scan edge memory channel P1 and P2, pro-
grammed scan does not start.
i Push [(F-2)∂F] to start the ∂F scan.
• Decimal points blink while scanning.
qr.qot.pp
qr.wpt.pp
o When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
!0 To cancel the scan, push [(F-2)∂F].
qw pp
qw pp