I Fine Programmed Scan/Fine ∂F Scan; I Memory Scan Operation - Icom IC-756PROII Instruction Manual

I Fine programmed scan/fine ∂F scan
Fine scan functions as programmed or ∂F scan, but
scan speed decreases when the squelch opens but
does not stop. The scanning tuning step shifts from
50 Hz to 10 Hz while the squelch opens.
q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Push [(F-5)SCAN] to select the scan screen.
e Set for programmed scan or ∂F scan as described
on previous page.
r Push [(F-1)PROG] or [(F-2)∂F] to start a scan.
• Decimal points blink while scanning.
qr.qot.pp
qr.wpt.pp

I Memory scan operation

q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Select memory mode.
e Push [(F-5)SCAN] to select the scan screen.
qr.qot.pp
qr.wpt.pp
r Set [RF/SQL] open or closed.
• See p. 57 for scan condition.
• If the [RF/SQL] control function is set as "AUTO," the
squelch is always open in SSB, CW and RTTY modes.
See pgs. 3, 69 for details.
t Push [(F-3)FINE] to start a fine scan.
• "FINE PROGRAM SCAN" or "FINE ∂F SCAN" ap-
pears.
qw pp
y When the scan detects a signal, the scan speed
decreases but does not stop.
u Push [(F-1)PROG] or [(F-2)∂F] to stop the scan;
push [(F-3)FINE] to cancel the fine scan.
t Push [(F-1)MEMO] to start the memory scan.
• Decimal points blink while scanning.
qw pp
y When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
u To cancel the scan, push [(F-1)MEMO].
2 or more memory channels must be programmed
for memory scan to start.
SCANS
qw pp
qr.qot.pp
qr.wpt.pp
qw pp
qr.qot.pp
qr.wpt.pp
7
59