Table of Contents
Advertisement
P/N 428668A
INSTALLING SPLASHGUARDS
The splashguards are shipped inside each case.
Install splashguard brackets before piping case.
After merchandisers have been leveled and joined,
and all drip piping, electrical and refrigeration
work has been completed, install the splashguards.
To Install splashguards:
1. Check to be sure that all splashguard brackets
are level with the floor. Tighten screws.
2. Align splashguard so that slots in the top of
splashguard match the tabs extending from the
base of the case as shown.
3. Push splashguard up onto tabs until lower edge
of splashguard swings onto bracket. Lower bot-
tom of splashguard onto bracket tabs.
4. Install the front and back splashguards first.
The left and right end angle splashguards have
two pre-drilled flanges on each end. Use one
screw to fasten each flange behind the front
and back splashguards at pre-drilled holes.
5. Install end facet splashguard on brackets; use
four screws in pre-drilled holes to fasten the
end facet splashguard to the left and right end
angle splashguards.
Optional flat end: The flat end splashguard is
installed last, as shown.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)
1
2
Attach retainer
before attaching end
END SPLASHGUARD
ATTACHMENT
Medium Temperature
3-3
Advertisement
Table of Contents
