Table of Contents
Advertisement
1-4
I
NSTALLATION
Seal Merchandisers
1. Apply Butyl Tape across the bottom joint. Be
sure to extend the tape up the back and front
of the case.
2. Use field-supplied silicone to fill any gaps
between the front support brackets.
Butyl Tape
Splashguard
Bracket
Splashguard
(for reference)
P/N 428668A
INSTALL SPLASHGUARD BRACKETS
The splashguard and brackets are shipped inside
each case.
Install splashguard brackets before piping case.
Use two screws per bracket. Attach brackets every
4 feet at pre-drilled locations.
Install splashguard brackets on faceted end in
locations shown.
After merchandisers have been leveled and joined,
and all drip piping, electrical and refrigeration
work has been completed, install the splashguards
as described in Section 3.
Two
screws
per
bracket
Front of CW2U-138
Bracket
at 4 ft
interval
Advertisement
Table of Contents
