Set Bad_Ep_Detect - Cisco MCS 7800 Series Administration Manual

Appendix A Command Line Interface (CLI) Commands

set bad_ep_detect

Syntax Description
enable
disable
Command Modes Admin
Command History Release
1.1
Usage Guidelines
Use this command to either enable or disable the bad endpoint detection feature. If this command is set
to enable, bad source endpoints will be dropped from conferences; if set to disable, the bad endpoint
will be kept in the meeting.
Examples
admin:set bad_ep_detect disable
Telepresence Multipoint Switch; drop bad endpoint: disable
Related Commands Command
show badep
OL-12586-02
set bad_ep_detect {enable | disable}
Enables bad endpoint detection feature; if detected, CTMS will drop a bad
endpoint from conferences
Disables bad endpoint detection feature.
Modifications
This command was first documented.
Description
Displays whether bad endpoint detection has been enabled or disabled
Cisco TelePresence System Release 1.4 Administrator's Guide
set bad_ep_detect
A-7