Cisco MCS 7800 Series Administration Manual page 32

System Settings
• SNMP service password set to "snmppassword". The password should be changed.
No trap receiver configured. Use the Trap Receiver Configuration fields in this window to configure
•
a trap receiver. The fields collect trap receiver username, password, authentication algorithm,
hostname or IP address, and port.
Figure 4-5
Figure 4-5
To edit SNMP settings:
Step 1 Click System Settings under the System Configuration folder in the Navigation Pane.
Step 2 Click the SNMP Settings tab. SNMP Settings displays a table providing the SNMP Settings
configuration fields.
Edit settings (as needed) as described in
Table 4-5
Field or Button
Engine ID
SNMP
Configuration
User Name
Cisco TelePresence Multipoint Switch Release 1.1 Administration Guide
4-30
shows the SNMP Settings screen.
SNMP Settings
SNMP Settings
Setting
(View only) The engine ID for the SNMP agent on this Cisco
TelePresence Multipoint Switch. This number is usually based on the
CTMS MAC address.
If you configure the trap receiver, this engine ID is used to create a
trap user on the trap receiver system and to compute the security
digest for authenticating and encrypting packets sent to a user on the
remote host.
Enable or disable SNMP for CTMS. Click the appropriate radio
button to select.
When SNMP is enabled, supply a password for the SNMP server in
the Configuration area.
SNMP server username.
Chapter 4
Table 4-5
Configuring CTMS Administration Software
OL-12586-02