Cisco MCS 7800 Series Administration Manual page 89

Chapter 8 Interoperability with Legacy Video Conferencing Devices
Table 8-5
Field or Button
Maximum Rooms
Video Announce
Hosted Meeting
Host Room Number
Quality
Interop
CUVC Number
OL-12586-02
Static Meeting Settings
Setting
Defines the maximum number of Cisco TelePresence rooms allowed
to dial into in a static multi-point meeting. The range for this setting
is from 2 to 48.
If this option is selected, when a new room joins the meeting, the new
room is displayed on-screen for 2 seconds. Options are Yes and No.
Click the appropriate radio button to select.
Hosted meetings mean that one particular room is identified as the
host for a meeting; other meeting rooms will not be added to the
meeting until the host room dials in. If you have selected "Video
announce," then each meeting room will be displayed in 2-second
intervals in the order that they joined the meeting.
Options are Yes and No. Click the appropriate radio button to select.
Defines the host Cisco TelePresence System room number.
This field sets the system bandwidth and screen resolution. A higher
bandwidth increases video quality, but may also cause packets to be
dropped and video to be interrupted. Choices:
Highest Detail, Best Motion: 4Mbps 1080p
•
Highest Detail, Better Motion: 3.5Mbps, 1080p
•
Highest Detail, Good Motion: 3Mbps, 1080p
•
• Highest Detail, Best Motion: 3Mbps, 720p
• Highest Detail, Better Motion: 2Mbps, 720p
• Highest Detail, Good Motion: 1Mbps, 720p
Default is Highest Detail, Best Motion: 4Mbps 1080p.
Determines whether this particular Cisco TelePresence multipoint
meeting accepts legacy Cisco Unified Video Conferencing (CUVC)
systems (interop).
Options are Yes and No. Click the appropriate radio button to select.
Defines the number that CTMS dials to establish contact with
CUVC. Each CUVC number must be unique for each CTMS
conference. The CUVC number consists of the service prefix and
then the remaining dialed digits. The service prefix can be the same
for different meetings. The remaining digits in the dialed number
designate the CUVC meeting instance.
Each CTMS conference requires it owns CUVC meeting instance.
This number must start with the CUVC service prefix
Note
defined during CUVC configuration.
Cisco TelePresence Multipoint Switch Release 1.1 Administration Guide
Configuring Cisco TelePresence Interoperability
8-87