Show Network All; Show Network Eth0 - Cisco MCS 7800 Series Administration Manual

show network eth0

show network eth0
Syntax Description
None
Command Modes
Admin
Command History Release
1.1
Usage Guidelines
Use this command to display basic Ethernet 0 platform network information.
Examples
admin:show network eth0
Ethernet 0
DHCP
IP Address
Link Detected: yes
Duplicate IP : no
DNS
Primary
Options
Domain
Gateway
Related Commands Command

show network all

show network failover Displays NIC Teaming network fault tolerance information
show network
ip_conntrack
show network
max_ip_conntrack
show network route
show network status
Cisco TelePresence System Release 1.4 Administrator's Guide
A-42
show network eth0
Modification
The command was first documented.
: disabled
: 172.28.68.76
: 171.70.168.183
: timeout:5 attempts:2
: cisco.com
: 172.28.68.1 on Ethernet 0
Description
Displays all show network command information
Retrieves the current utilization of ip_conntrack
Retrieves the current ip_conntrack_max information
Displays basic network route information
Displays basic network status information
Appendix A
Status : up
IP Mask : 255.255.252.0
Mode : Auto enabled, Full, 1000MB/s
Secondary : 171.68.226.120
Command Line Interface (CLI) Commands
OL-12586-02