JETWAY NF792R Series User Manual page 40

Bits per second
Use this item to selects serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require lower speeds.
The optional settings are: [9600]; [19200]; [57600]; [115200].
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data, if
the receiving buffers are full, a 'stop' signal can be sent to stop the data flow.
Once the buffers are empty, a 'start' signal can be sent to re-start the flow.
Hardware flow control uses two wires to send start/stop signals.
The optional settings are: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff].
Data Bits
The default setting is: [8].
*This item may or may not show up, depending on different configuration.
Parity
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
 PC Health Status
Press [Enter] to view current hardware health status, set shutdown temperature, or
make further settings in 'SmartFAN Configuration'.
 SmartFAN Configuration
Press [Enter] to make settings for SmartFAN Configuration:
CPUFAN/SYSFAN1 Smart Mode
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN/SYSFAN1 Full-Speed Temperature
Use this item to set CPUFAN full speed temperature. Fan will run at full speed
when above the preset temperature.
35