JETWAY NF792R Series User Manual page 37

ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select 'AT or ATX Mode' on MB jumper at first (refer to
AT_MODE jumper setting Pin 1&2 of for ATX Mode & Pin 2&3 of AT Mode
Select).
 Serial Port Console Redirection
Press [Enter] to make settings for the following sub-items:
COM1
Console Redirection
Use this item to enable or disable COM1 Console Redirection.
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], user can make further settings in the 'Console
Redirection Settings' screen:
 Console Redirection Settings
The settings specify how the host computer and the remote computer (which the
user is using) will exchange data. Both computers should have the same or
compatible settings.
Press [Enter] to make settings for the following sub-items.
COM1
Console Redirection
Terminal Type
Emulation: [ANSI]: Extended ASCII char set; [VT100]: ASCII char set;
[VT100+]: Extends VT100 to support color, function keys, etc.; [VT-UTF8]:
Uses UTF8 encoding to map Unicode chars onto 1 or more bytes.
The optional settings are: [VT100]; [VT100+]; [VT-UTF8]; [ANSI].
Bits per second
Use this item to select serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require lower speeds.
The optional settings are: [9600]; [19200]; [38400]; [57600]; [115200].
32