Installing The Chassis On A Tabletop Or Flat Surface; Supplemental Bonding And Grounding Connections - Cisco XR 12404 Installation Manual

Chapter 3 Installing the Router

Installing the Chassis on a Tabletop or Flat Surface

Step 1
Step 2
Step 3

Supplemental Bonding and Grounding Connections

OL-13830-02
Use the following procedure to install the Cisco XR 12404 Router on a tabletop
or other stable flat surface.
Move the router as close to the installation location as possible.
With one person positioned at the front and rear of the chassis, lift the chassis off
of the pallet and position the chassis on the flat surface.
Secure the chassis to the flat surface to ensure it does not fall off.
You can use the same mounting hardware that secured your router to the shipping
pallet to secure the chassis to the flat surface.
Before you connect power or turn on your Cisco XR 12404 Router, you must
provide an adequate system ground for the router. The equipment grounding
should be in accordance with local and national electrical codes.
If you are not installing the Cisco XR 12404 Router in a NEBS environment, you
can choose to bypass these guidelines and rely on the safety earth ground
connection supplied via the 5-15 15A North American plug to the AC-powered
PEMs, and the main terminal block ground connection for DC-powered PEMs.
On Cisco XR 12404 Routers configured for AC-input operation, the AC PDU
•
is equipped with a three-wire electrical grounding-type connector that accept
three-wire, grounding-type AC power cords such as the power cords shipped
with the router. This is a safety feature.
Supplemental Bonding and Grounding Connections
Cisco XR 12404 Router Installation Guide
3-8