Table of Contents
Advertisement
POST-SERVICE PRECAUTIONS
Initializing this Unit
Make sure to initialize this unit after replacing the microcomputer or any peripheral equipment, or the
digital PCB.
1. Press the power button to turn off the power.
2. While holding down buttons "TUNER PRESET CH -" and "TUNER PRESET CH +" simultaneously, press
the power button to turn on the power.
3. Release the buttons after confirming that the display flashes at 1-second intervals.
＊ The unit is initialized.
Use network initialization mode to initialize the network related settings.
NOTE： • If the unit fails to enter the service mode in step 3, repeat the procedure from step 1.
• Initializing the device restores the customized settings to the factory settings. Write down
your settings in advance and reconfigure the settings after initialization.
TUNER
PRESET CH -
X
JIG FOR SERVICING
Use the following jigs (extension cable kit) when repairing the PCBs.
Order with your dealer for the jigs your dealer if necessary.
8U-110084S : EXTENSION UNIT KIT
:
8U-110136S : EXTENSION UNIT KIT
:
(See
ONLINE PARTS
LIST)
TUNER
PRESET CH +
1 Set
1 Set
7
Hide quick links:
Advertisement
Table of Contents
