Marantz SR5014 Service Manual page 144

Paths to be confirmed Display
DIGITAL fig.A03a
A03Z2DIG
3
fig.A03b
(ZONE2)
***.*
fig.A04a
A05HDMI
4 HDMI
fig.A04b
***.*
fig.A05a
Analog AD
A06AD
5
(MAIN ZONE) fig.A05b
***.*
Analog Amp Assign
A07Z2ASS
6 (Amp Assign : fig.A06
***.*
ZONE2)
ZONE2 Downmix
fig.A07a
A22Z2-DM
7 (Amp Assign :
fig.A07b
***.*
ZONE2)
Settings
Input Source : HEOS Music
Input Mode : Auto
Sound mode : STEREO
ZONE2 Source : HEOS Music
Amp assign : ZONE2
MAIN ZONE : On
ZONE2 : On
Input Source : CBL/SAT
Input Mode : HDMI (fixed)
Sound mode : STEREO
Amp assign : Surround Back
MAIN ZONE : On
ZONE2 : Off
Input Source : CBL/SAT
Input Mode : Analog (fixed)
Sound mode : MULTI CH STEREO
Vol 60(-20dB)
Amp assign : Surround Back
Speaker Config ALL Speaker = Small/SW = Yes(2ch)
MAIN ZONE : On
ZONE2 : Off
Input Source : CBL/SAT
Input Mode : Auto
Sound mode : STEREO
Z2 Source : CBL/SAT
Vol 60(-20dB)
Amp assign : ZONE2
MAIN ZONE : On
ZONE2 : On
Input Source : CBL/SAT
Input Mode : Auto
ZONE2 Source : Source
ZONE2 Vol : 60
Amp Assign : ZONE2
MAIN ZONE : On
ZONE2 : On
144
What to confirm
• Digital(PCM) input ⇒ Speaker output (Surround Back (ZONE2) L/R)
• Digital(PCM) input ⇒ Pre OUT output (ZONE2 L/R)
( b Only HEOS Music can be set as the input source.)
• HDMI input ⇒ Speaker output (Front L/R)
( b The input source can be switched to any source except CBL/SAT.)
• Analog input ⇒ Speaker output (Front L/R, Center, Surround L/R, Surround Back L/R)
• Analog input ⇒ Pre OUT output SW(20Hz)
( b The input source can be switched to any source except CBL/SAT.)
( b Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)
• Analog input ⇒ Speaker output (Surround Back (ZONE2) L/R)
• Analog input ⇒ Pre OUT output (ZONE2 L/R)
( b The input source for ZONE2 can be switched to any source except CBL or SAT.)
(Do not select "SOURCE" as the input source for Zone2.)
( b Source for ZONE2 does not change even when Source for the MainZone is changed.)
( b Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)
• Analog input ⇒ Speaker output (Surround Back (ZONE2) L/R)
• Analog input ⇒ Pre OUT output (ZONE2 L/R)
( b The input source can be switched to any source except CBL/SAT.)
(Do not change the input source for Zone2 from "SOURCE".)
( b Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)