Connect Ethernet Devices - Cisco SOHO 77 Hardware Installation Manual

Chapter 2 Installation
4.
5.
6.

Connect Ethernet Devices

Table 2-2
the connections for each device; and the settings of the router TO HUB/TO PC button (the default setting
is IN).
Table 2-2 Ethernet Device Connections for Cisco 827, Cisco 827-4V, and SOHO 77 Routers
Network Device
Connected To Router
Hub with equivalent to
router TO HUB/TO PC
button
Hub with equivalent to
router TO HUB/TO PC
button
Hub without equivalent
to router TO HUB/TO
PC button
Server, PC, or
workstation
1. Cisco provides a yellow straight-through cable. You provide crossover or additional straight-through cables. For details on
cables, see Appendix A, "Specifications and Cables."
2. Hub vendors choose different names for the button that controls the cable selection. This table uses the
Cisco 1528 Micro Hub 10/100 with an MDI/MDI-X button as an example. Determine the button name and setting for your
particular hub. Refer to your hub documentation for details.
78-6854-03
Connect a terminal or PC to the router for software configuration using the command-line interface
(CLI) or for troubleshooting.
Connect the router to the power source.
Verify the links using the router LEDs.
lists the Ethernet devices you can connect to Cisco 827, Cisco 827-4V, and SOHO 77 routers;
Ethernet Cable
Router Port Type
ETHERNET port 1 Straight-through
ETHERNET port 1 Straight-through
ETHERNET port 1 Straight-through
ETHERNET port 1 Straight-through
Router HUB/NO
HUB Button
1
Setting
IN
OUT
OUT
OUT
Cisco 827 and SOHO 77 Routers Hardware Installation Guide
Installing the Router
Network Device
2
Button Setting
MDI (IN)
MDI-X (OUT)
MDI-X (OUT)
–
2-7