Connect To The Management Ethernet Port - Cisco N540-FH-CSR-SYS Install Manual

Connect to the Management Ethernet Port

Figure 17: Connecting the USB Console Cable to the Chassis
1
Follow this procedure to connect a data terminal to the console port:
1. Set your terminal to these operational values: 115200 bps, 8 data bits, no parity, and two stop bits.
2. Attach the terminal end of the cable to the interface port on the data terminal.
3. Attach the other end of the cable to the console port.
Table 3: RJ-45 Straight-through Cable Pin-outs
RJ-45 Pin
1
2
3
4
5
6
7
8
Connect to the Management Ethernet Port
You must complete the initial router configuration.
Install the Device
14
RJ45 Port 2 Console cable
Signal
—
—
Tx
Ground (GND)
GND
Rx
—
—
Install the Device